Beautifully hand-crafted Field Gate/ Farm Gate manufactured from the finest joinery graded, smooth planed, slow grown Redwood Pine. Traditional time served techniques including mortise, tenon and dowel joints to prevent the frame from “pulling” apart and ensuring a long lasting, durable field gate. Handcrafted in the UK to any width or height. Installation available.Width: Select from “Drop down” above. Width shown is for exact width of gate required. To calculate the width required, measure between the posts/ pillars and reduce the size by 270mm (10 1/2″). This gives the clearance needed for the hinges.Height: from 3ft to 5ft (914mm to 1m 520mm) – taken to the highest point of gate (inc horns).
- Take three measurements between existing pillars or posts.
- Reduce the LOWEST size by 260mm for single field gate or 270mm for double field gate.
- That’s it! The size left after the reduction is the gate width required. Online, we offer gate width’s to the nearest inch, simply select the closest size (lower) from the drop down menu – or call to order for an exact width.
nnPlease note: If no pillars or posts on there, measure the opening and reduce by 2 x posts. Gates up to 10ft wide should use 100mm x 100mm (4″ x 4″) posts, over 10ft use 150mm x 150mm (6″ x 6″) posts.Measuring for Automated Gates:For above ground automation, rear hung on the back of the posts take the smallest measurement and reduce by 50mm (this will give you the actual gate size to order).For above ground automation, hung in the centre of the posts take the smallest measurement and reduce by 150mm (this will give you the actual gate size to order).For below ground automation, rear hung on the back of the posts take the smallest measurement and plus 20mm (this will give you the actual gate size to order).For below ground automation, rear hung in the centre of the posts take the smallest measurement and reduce by 260mm (this will give you the actual gate size to order).