Yes. Not all entrance width’s are the same. You can order online to the nearest inch or call our team on 0800 6124 965 to order to the millimeter.

Gate Furniture (hinges etc) 2 x adjustable hinges, hinge pins with plate to mount on posts/ pillars, closing receiver and opening latch included with each gate (enough to hang direct on existing posts/ pillars).

Finish. Choice of black, white or anthracite grey. For a longer lasting finish, we recommend upgrading finish to “Longlife”.

As standard, the position of the hinge will be 6″ (150mm) from the bottom edge of gate and 6″ (150mm) from top edge of gate. If you require these to be different (if for example you already have pins set into a post/ pillar), please call us.

Any competent DIY’er can fit a side gate. Take a look at our guide here for more information or download PDF.

Our long life system provides the ultimate protection against rust and chips. The gates are sand blasted after production then a zinc primer is applied followed by a smoother, thicker top coat.

Our standard finish will scratch and chip easier resulting in more maintenance and a higher risk of rust spots forming.

We are able to paint any gate in any RAL colour. RAL colours are coded so by providing us with the RAL code we can finish your gate to your chosen colour.

Do see all the RAL colours and codes…see https://www.ralcolorchart.com/

Yes. For any product up to £6000.

Zopa Ltd t/a DivideBuy credit agreements are not regulated by the Financial Conduct Authority and do not fall under the jurisdiction of the Financial Ombudsman Service. Credit is available to permanent UK residents aged 18+, subject to status, any missed payments may affect your ability to obtain credit from DivideBuy and other lenders. Please spend responsibly.

10 year workmanship warranty. This covers all welds on the gate.

It does not cover rust. Rust can occur when the gate paint is chipped and the damage not repaired. General maintenance and care of the gate is the owners responsibility.

Taken to the highest point of each gate.

We recommend allowing a 50mm (2″) clearance between the bottom edge of gate and driveway (as long as the drive is level). If you require a more exact height, please contact us to order.

Taken as the actual gate (not opening size).

Yes, by our skilled fabricators.

All of our products are crafted by hand from our factory in Devon and sent across the whole of the UK (mainland).

To keep installation cost’s down for the end user, we work closely with a number of gate installation companies throught the UK. This way we are able to recommend a reliable company close to you saving you additional travel expense cost’s.

Call our team to discuss on 0800 6124 965.